吉他1 - 觸控式歌曲

步驟1：製作

這是什麼?

Play different tunes by using the micro:bit’s touch sensor.

這兩個影片向您展示了製作內容和編碼方式：

運作方式

• This project is the same as the Jukebox project but instead of using the micro:bit’s buttons, you’ll make your own input device using cardboard covered in strips of tin foil connected by crocodile clip leads to the micro:bit's pins.
• Flash the program onto your micro:bit.
• Attach one end of three crocodile clip leads to pins 1, 2 and GND (ground or Earth pin). Attach the other ends to a cardboard guitar or keyboard.
• With one finger touch the foil connected to GND, and with another finger touch the foil connected to pin 1 and then pin 2. It should play a different tune depending on which strip of foil you touch.
• The micro:bit is using pins 1 and 2 as touch inputs. When you touch either of these pins and the GND pin, you’re completing an electrical circuit. A small amount of electricity flows through you, the micro:bit can detect it and the program triggers the playing of a tune.
• If you do not have a V2 micro:bit, which plays sound, attach headphones to pins 0 and GND.

你需要的東西

• micro:bit和選配電池组
• MakeCode 或, Python 編輯器
• three crocodile clip leads
• cardboard, tin foil, glue stick and scissors to make a guitar or keyboard
• optional headphones, buzzer, or speaker with additional two crocodile clip leads for V1 users

步驟2：編碼

1from microbit import *
2import music
3
4while True:
5    if pin1.is_touched():
6        music.play(music.ODE)
7    if pin2.is_touched():
8        music.play(music.BLUES)
9

步驟3：進階

• Change the tunes that are played when you touch the tin foil.
• 編寫自己的音樂。
• Show different pictures, letters, numbers, or words depending on which tune you picked.